One Touch Reverse

Chapter 5 · Manual page 239

One touch Reverse function (hereinafter referred to as: Tracking function) will automatically and silently remember driven paths of 50m when the speed is 016mph (025km/h) without any operation from you. When you drive into difficult road conditions, such as encountering another vehicle or object on a narrow road, a dead end street other scenarios that require you to reverse, you can enable the tracking function, which can automatically control the steering and speed, to help you reverse according to the original path taken and remove you from a difficult situation. Note: The tracking function can be used when the valid memory path length is more than 1 meter and the road width of the vehicle is greater than 3 meters. Tip: When other intelligent driver assistance systems are running, the tracking function cannot silently remember the path, or the function cannot be used because of the unavailability of valid memory path. The tracking function assists reversing by the following steps:

  1. Methods to enable the function: Method 1: Click the “Reverse” button on the 360 interface to enable the function and enter the function interface; Method 2: Click the “Reverse” button on the HOME interface of the central screen to enable the function and enter the function interface; Method 3: Click the “Reverse” button in One Touch iAD on the APP menu interface of the central screen to enable the function and enter the function interface. After entering the tracking function interface, stop the vehicle and maintain brake pedal application, you are then able to view the total length of the expected tracking process and click”Reverse”and follow the operation prompts on the interface.
  2. Run the function: During tracking, the remaining tracking distance will be displayed in real time. The function will automatically control the steering and speed of the vehicle, but you still need to monitor the surroundings to be ready to take over and ensure the safe tracking. When it is about to reach the end of the tracking, the interface will display an advanced prompt stating that the function is is about to reach the end.
  3. Complete the function: Reverse tracking is completed when the function controls the vehicle to automatically reverse to the end of the memory path. After the function is completed, it will automatically engage P gear, and prompt: Tracking Completed. Pause and exit of the function:
  4. The tracking function will be paused in the following cases:
  5. Click [Pause] button in the function interface;
  6. Press the brake or open the door;
  7. The time from braking to stopping exceeds a certain period of time due to obstacles. After the function is paused for a certain period of time, you can still click the [Continue] button in the function interface to continue the tracking operation.
  8. The tracking function will be exited in the following cases:
  9. The driver intervenes with the driving
  • Turn the steering wheel
  • Move the shift lever *The function has no response when the throttle is applied;
  1. Click [Exit] button in function interface (available only when the function is paused);
  2. The function is paused for more than 1 minute due to obstacles;
  3. Abnormalities such as system failure or fault detection.