Important Instructions for Using Rear Collision Assist System
Chapter 5 · Manual page 245
- Specific roadside buildings (such as high or oblique guardrail), weather conditions, weight of loads on the vehicle, road conditions (such as road bumps or sharp turns), coverings on the car, etc. will affect the recognition effect of the rearward driver assistance system sensor, thus a false alarm may be issued.
- The system may not be able to warn the driver of the vehicles that are approaching very fast from the rear or warn the driver when the vehicle approaches from - around a bend with small turning radius.
- The system cannot work properly when a towing device is attached.
- The rear driver assistance system can only assist the driver to observe the surrounding environment and the driver must always pay particular attention to the surroundings of the vehicle and drive safely.
- The radar sensor in the rear bumper may be misaligned or damaged by a collision, and the system may be affected or automatically turned off.
- Do not paste or position any object on the warning lamp to avoid affecting the warning function of the system.
- To ensure that the radar sensor works properly, the rear bumper should be kept free of snow and ice and must not be covered.
- The rear bumper should only be repaired using automotive paint certified by the manufacturer, otherwise the system functions may be restricted or defective.