Child Restraints Groups and Installation Position
Chapter 4 · Manual page 187
Only approved child restraints suitable for children are allowed. Children taller than 1.5m may directly use the seat belts in the vehicle. Child restraints must comply with relevant regulations or standards, such as EU regulations ECE-R129. Recommended Child Restraint Systems ECE-R129 classification is based on a child’s height
| Child Height | Recommended a) |
|---|---|
| 40~83cm | Maxi Cosi Pebble 360 |
| 76~105cm | Britax Römer TriFix2 i-Size |
| 100~135cm | Britax Kidfix i-Sizeb) |
| 100~150cm | Graco Booster Basic R129 |
| Note: a) Always refer to the CRS manual for instructions of use. b) For child restraint with back, please, • ensure lap belt is in the SecureGuard, and; • ensure diagonal belt is not in the SecureGuard. | |
| Suitable Seats for Attaching Child Restraint Systems | |
| Seating Position | |
| --- | --- |
| Seating Position | Front Driver |
| Seating position suitable for universal belted(yes/no) | No |
| I-Size seating position(yes/no) | No |
| Seating position suitable for lateral fixture(L1/L2) | No |
| Largest suitable rearward facing fixture (R1/R2x/R2/R3) | No |
| Largest suitable forward facing fixture(F1/F2x/F2/F3) | No |
| Largest suitable booster fixture(B2/B3) | No |
- 1When installing a CRS on the front passenger seat, adjust the front passenger seat as high as possible to securely install the CRS.
- 2When installing a CRS on the second row center seat, pull the buckle out to ensure that the CRS is in a correct and stable position.
- 3Only applicable for installation with seat belt.
- During the installation of the CRS, the backrest angle of seats should be adjusted reasonably to ensure that the CRS remains stable.
- During the installation of the CRS, the height of the headrest should be adjusted reasonably or the headrest should be removed to make the backrest of CRS flat to the vehicle seat. Do not remove the head restraint when using a booster cushion with no backrest. Ensure all removed head restraints are stowed safely. Refit the head restraint once the CRS has been removed.