Parking Brake System - Electronic Parking Brake (EPB)
Chapter 4 · Manual page 208
In cases where the EPB cannot be released due to failure, DO NOT move the vehicle with the rear wheels in contact with the road surface, this may cause damage!
P gear for parking and the EPB are triggered by the same switch. A motor noise may be heard when applying or releasing the EPB. When the vehicle is stationary, press the EPB switch to apply the EPB. With the EPB applied, press the brake pedal to shift from P gear to other gears, and the EPB will be released. With the EPB applied and the vehicle not engaged in P gear, when the driver fastens seat belt, shifts to D or R gear, and presses the accelerator pedal, the EPB will be released. Note: Always apply the EPB system every time you leave the vehicle.
- The EPB cannot be released when the vehicle fails to shift from initial P gear to other gears. In the event of a flat battery where it is not possible to apply or release the EPB. In such
- jumper cables should be used for emergency vehicle start. Please refer to ‘Jump Start’ in ‘Emergency Information’ section. Emergency Braking with EPB
Inappropriate use of the EPB for emergency braking may lead to accidents and injuries. Do not apply the EPB for braking whilst moving, unless in emergency.
During emergency braking using the EPB, DO NOT switch off the power system, this could result in serious injury. When the car is in motion, in case of any emergency, such as the car cannot be stopped by the brake pedal, it can be decelerated by pressing and holding the EPB switch. A continuous audible warning will sound during emergency braking by long pressing the EPB switch. To cancel the emergency brake